What to do if Acteon XMIND TRIUM Medical Equipment shows a warning?
If you encounter a warning with your Acteon Medical Equipment, and it continues after the initial alert, switch off the X-MIND trium using the main switch. Wait for 30 seconds, and then switch it back on.
What to do if Acteon XMIND TRIUM has an anomaly?
If you experience an anomaly with your Acteon Medical Equipment, restart the Workstation. This may resolve the issue.
Messages about operator safety, patient injury, or device damage.
Detailed procedure for positioning patients for PAN/CBCT scans.
Details the patient and remote emergency switches for stopping the device.
Step-by-step guide to power on the X-MIND trium system.
Steps to execute a Panoramic X-ray acquisition.
Explains error codes and the actions to resolve them.
General| Voltage | 60-90 kV |
|---|---|
| Frequency | 50/60 Hz |
| Resolution | Up to 75 μm |
| X-ray Generator | High frequency DC generator |
| Detector Type | Flat Panel Detector |
| Reconstruction Time | Less than 1 minute |
| Software | ACTEON Imaging Suite |
| Applications | Implantology, Endodontics, Orthodontics, Oral Surgery |
| Technology | Cone Beam Computed Tomography |
To Next Page
