Preset Run
Type the Preset Point number into the Preset field, click on , and the
camera will turn to the appointed point.
2.5.2 Sequence
The Sequence setting can be found under this path: Pan Tilt> Sequence.
The Sequence function supports eight Sequence Lines. Each Sequence Line
consists of 64 Preset Points. Please refer to the instructions below to program a
Sequence Line.
NOTE: Before setting this function, users must pre-define at least two
Preset Points.
Sequence Setting
⚫ Sequence Line
The Sequence Lines are numbered from 1 to 8. Select a Sequence Line
from the drop-down menu. Then click on to enter the setup
page.
⚫ Sequential Preset Points Setting
Please setup each Preset Point of the programmed Sequence Line in
order, assigning a Preset Point from the “NO.” list for the specified
number of Preset Point and entering Dwell Time (0 sec. to 255 sec.) into
the corresponding fields. Click on <Save> when finished.
⚫ Sequence Reset
To reset the sequence setting of each line, please click on <Reset> on
the setup page. Then click on on the left to refresh the page in
order to enter the new settings.
To Next Page
Loading...
