ACTi A713 - Video Configuration

72
2.3.1 Video Configuration
The Video Configuration setting can be found under this path: Streaming>
Video Configuration.
Encoding
Select <Yes> from the drop-down menu to enable Stream 2~Stream 4 encoding.
Or select <No> to disable the streaming encoding.
Encode Type
The available video resolution formats include H.265, H.264, and MJPEG.
Users can select the preferred encode type from the drop-down menu.
Resolution
Video format and resolution combination will vary by users’ configuration.
Framerate
Video framerate is for setting the frames per second (fps) if necessary.
⚫ 8M Models (F/B/K/6)
The default setting of Stream 1 is 30 fps (NTSC) or 25 fps (PAL). The
maximum framerate range of each stream will change according to the
selected video resolution.
⚫ Stitching Bullet Model (3)
The default setting of Stream 1 is 30 fps (NTSC) or 25 fps (PAL). The
maximum framerate range of each stream will change according to the
selected video resolution.
⚫ Fisheye Model (8)
The default setting of Stream 1 is 25 fps (Front End) or 20 fps (Back
end). The maximum framerate range of each stream will change
according to the selected video resolution.
NOTE: Low framerate will decrease video smoothness.
Profile
Users can set H.265/H.264 Profile to <High Profile> or <Main Profile> according
to its compression needs. With the same bit rate, the higher the compression
ratio, the better the image quality is. The default setting is <Main Profile>.