⚫ MJPEG over HTTP port
The default setting of MJPEG over HTTP Port is 8008; the MJPEG over
HTTP Port should be set as 8008 or from the range1024 to 65535.
⚫ HTTPS port
The default setting of HTTPS Port is 443; the HTTPS Port should be set
as 443 or from the range 1024 to 65535.
NOTE: Please make sure the port numbers set above are not the same
with each other; otherwise, network conflict may occur.
⚫ RTSP URL
When users use RTSP players to view the live streaming, the camera
provides the flexibility to configure the streaming access name for
stream 1 to stream 4. The streaming format is rtsp://<ip
address>:<rtsp
port>/<access
name>
. Take a camera whose IP address is set as 192.168.0.100 for example, if users enter “liveview.1”
in the blank of stream 1 access name, the streaming address of stream
1 will be rtsp://192.168.0.100:554/liveview.1.
NOTE: The maximum length of the access name is 32 characters,
and the valid characters are A-Z, a-z, 0-9 and !#$%&’-.@^_~.
IPv6 Address Configuration
If the network supports IPv6, users can check the box beside <Enable IPv6>
and
click
<Save>.
An
IPv6
address
will
ap
pear
beside
<Address>,
and
users
can use it to connect to the camera.
To Next Page
Loading...
