Traps for SNMP v1 / v2 / v3
Traps are used by the camera to send messages to a management system for
important events or status changes.
⚫ Enable Traps
Check the box to activate trap reporting.
⚫ Trap address
Enter the IP address of the management server.
⚫ Trap community
Enter the community to use when sending a trap message to the
management system.
Trap Option
⚫ Warm Start
A Warm Start SNMP trap signifies that the SNMP device, i.e. IP camera,
performs software reload.
Click on <Save> when completed.
To Next Page
Loading...
