ACTi ACM-3001 Installation

www.acti.com
ACTi
Knowledge Base
Category: Installation & Configuration Note
Sub-category: Application
Model: ACM-3511/ACM-3011
Firmware: N/A
Software: N/A
Author: Victor.Wang
Published: 2009/09/02
Reviewed: 2010/01/21
1
Tips for 3-Inch Dome Installation
Contents
Introduction
Installation of camera plate
Installation of camera
Installation of front cover
Future design and improvement
Introduction
Some customers have a problem with installing a 3 inches dome. After adjusting the viewing
angle, zoom or focus, the lens part will be moved again by the rubber and black plastic cover
when they closing the dome cover. The purpose of this document is to guide customer through
the procedures of installing a 3 inches dome efficiently.
Installation of camera plate
1. Use the drill template, and drill a hole with φ 35 on the ceiling.

ACTi ACM-3001 Specifications

General

Model	ACM-3001
Device Type	Network Camera
Connectivity Technology	Wired
Form Factor	Dome
Sensor Type	CMOS
Lens Type	Fixed
Focal Length	3.6 mm
Aperture	F2.0
Day/Night	Yes
Video Compression	H.264, MJPEG
Frame Rate	30 fps
Operating Temperature	-10°C to 50°C
Minimum Illumination	0.5 Lux
Network Interface	Ethernet
Power Supply	12V DC
Features	IP66
Protocols	ONVIF