To set up WPS:
1. Enable WPS by clicking in the Enable radio button.
2. Click Apply to save your changes.
3. If connecting a device to the wireless network with a WPS AP PIN, write down
the PIN displayed after Current WPS AP Pin, then enter the PIN in the device’s
WPS AP PIN configuration.
4. If connecting a device to the wireless network with PBC (Push Button
Configuration), click Connect, then press the PBC-compatible button on
the device within two minutes.
5. If the connecting device uses the End Device PIN method, enter the PIN in the
appropriate text box, then enter in the device’s End Device PIN configuration.
To Next Page
Loading...
