6
Introduction
Rear Panel
The rear panel of the Gateway features 10 ports, and a Reset button.
Power Port
The Power port is used to connect the Power cord (Model No. CDS036-
W120U, made by Adapter Technology Co Ltd) to the Gateway.
Reset Button
Depressing the Reset button for 10 seconds will restore the Gateway’s factory
default settings. The reset process will start after releasing the button.
WARNING! Do not unplug the Power cord from the Gateway
during the reset process. Doing so may result in permanent damage
to the Gateway.
SFP Cage
The SFP cage is used to connect the Gateway to a service provider connection
via optical fiber cable.
WAN Ethernet Port
The WAN Ethernet port is used to connect the Gateway to a WAN connection
via an Ethernet cable.
LAN Ethernet Ports (4)
The LAN Ethernet ports are used to connect computers to the Gateway via
Ethernet cable. The Ethernet ports are 10/100/1000 Mbps auto-sensing ports,
and either a straight-through or crossover Ethernet cable can be used when con-
necting to the ports.
USB Port
The USB port is used to connect the Gateway to a USB device.
To Next Page
Loading...
Need help?
General
