ActionTec T3200M - Getting Started With the Gateway

Step 2: Pairing with your Actiontec T3200M
or wireless access point
If you have an Actiontec T3200M (as identified
at the beginning of the instructions) press
the button on the front of the device for at least
5 seconds. If you have a wireless access point
instead, simply press the WPS button on the front
of your wireless access point.
Press the OK button on the front of your wireless
digital box.
3
OK
Installation is now complete. The next step is to set up
your Optik TV remote.
Note: If the set-up is unsuccessful, an error screen will appear
prompting for a manual restart. Refer back to your order confirmation
email for your Optik TV Self-Install Kit. It will include an 11-digit
activation code, which is only required if your set-up is unsuccessful.
Actiontec T3200M
Wireless access point
ACCESS
POINT
POWER
WPS
PAIRED
LINK
OR
2
1
3
4
Your wireless digital box will automatically restart to
complete registration. This will take approximately
5 minutes, but may take longer if updates are
required.