Need help?Do you have a question about the ACTpro 1030e and is the answer not in the manual?
General| Reader Type | Contactless |
|---|---|
| Connectivity | Wired |
| Reading Range | Up to 10 cm |
| Tamper Detection | Yes |
| Supported Card Types | MIFARE, DESFire, ISO14443 |
| Reading Technology | RFID |
| Interface | RS485, OSDP |
| Dimensions | 120 mm x 80 mm x 25 mm |
| Compatibility | ACTpro door controllers |
| Operating Temperature | -20°C to +55°C (-4°F to +131°F) |
| Operating Humidity | 5% to 95% (non-condensing) |
Details compliance with FCC Rules part 15 for ACTpro readers, including conditions for operation and interference.
Highlights key features of ACTpro RFID readers, including compatibility, buzzer, LED, and output configuration options.
Illustrates terminal connections for ACTpro 1040e, 1050e, and 1060e readers.
Details the wiring connections for the ACTpro 1030e reader using its pigtail cable.
Provides suggested colour coding for using CAT5 or CAT6 cabling with ACT readers.
Diagrams and instructions for wiring ACTpro readers for Clock & Data entry.
Diagrams and instructions for wiring ACTpro readers for Clock & Data exit.
Diagrams and instructions for wiring ACTpro readers for Wiegand entry mode.
Diagrams and instructions for wiring ACTpro readers for Wiegand exit mode.
Illustrates the steps for mounting the ACTpro 1030e reader, including screwing to the surface and placing caps.
Details the process for surface mounting ACTpro 1040e, 1050e, and 1060e readers.
Illustrates the steps for flush mounting ACTpro 1040e, 1050e, and 1060e readers.
Specific instructions for flush mounting ACTpro 1040e, 1050e, 1060e readers to a UK pattress box.
To Next Page
