ACU-RITE SENC 150 - Preparing for Remounting; Installing Alignment Brackets; Determining Cable Direction

SENC 150 Reading Head Replacement Instructions
9
Installing end cap(s)
Slide brackets against
reading head snap into place.
Insert brackets at 45°
and twist to lock in scale grove.
Installing alignment brackets
 Attach the alignment brackets provided by inserting the top
ears into the bottom grooves in the scale case.
 Numbers and letters on reading head casting and alignment
brackets correspond when assembled.
Determining cable direction
 Determine cabel exit direction before mounting the encoder.
 To change the cable exit direction, remove the cover plate
and rotate it 180°.
7 Preparing the remounting
K1 - cable exit right side
K2 - cable exit left side
T-10 torx screw
Do not pull out the PCB!
Do not clamp the wires!
T-10 torx screw
1
1
1
1
1
1
max. 70 Ncm!
spring clip