9
Troubleshooting
11.. TThhee aallaarrmm wwiillll nnoott rreeaacctt ttoo tthhee ffoobb
a. Check the fob batteries (type CR2016).
b. Place the fob as near as possible to the alarm
system main unit. If it will now disarm there
are probably spurious radio signals in the
vicinity. Move the motorcycle to another area.
c. Check the system fuse. If the alarm has no
power it cannot power the radio receiver.
Switch on the motorcycle ignition - if it
disarms now the alarm’s power supply is at
fault (fuse or connections).
22.. FFaallssee aallaarrmmss..
RReemmeemmbbeerr!! TThhee aallaarrmm mmaayy tthhiinnkk iitt iiss bbeeiinngg ssttoolleenn,,
wwhhiicchh iiss ddiiffffeerreenntt ttoo iitt bbeeiinngg ffaauullttyy!!
a. Enter Diagnostic mode and find out why the
alarm is/was reacting.
b. Take appropriate action - such as:
i. Enter Convenience Mode if it’s a windy
day (see page 4).
ii. Check earth/power connections if you
repeatedly get a ‘power interrupted’
signal.
33.. TThhee aallaarrmm ffuussee kkeeeeppss ffaaiilliinngg..
The system cannot ‘blow’ the fuse. It is what the
alarm switches that blows the fuse - usually the
indicators. Make sure there are no shorts in the
indicator system and if a new fit, make sure the
alarm PINK wire(s) is/are not connected to the
negative side of one, or both of the m/c indicators.
Spares and Accessories
Acumen can supply a range of spares &
accessories to enhance the features of the CAT3.1
system:
1. Spare and replacement remote fobs and
batteries.
2. The key fob can be up-graded to the same flip-
fob as used on the Acumen ‘Thatcham’
specification CAT1 and CAT21 systems. The Flip-
fob uses Microchip KeeLoq
®
code-hopping
technology which prevents scanning and
recording of transmitter codes. When ordering,
specify Acumen part number 51020 and your
make, model and year of motorcycle.
NNOOTTEE
The Acumen CAT3.1 cannot ‘know’ both types
of fob at the same time. If it ‘knows’ the standard
fob, it cannot ‘know’ a flip fob at the same time. It
can ‘know’ 2 x standard fobs at the same time, or 2 x
flip fobs at the same time, but not 1 of each.
3. Different coloured System LED’s to match your
motorcycle (Green, Red, White, Blue, Yellow)
4. Acumax 900 Intelligent ‘float’ battery charger
5. Extra, external sirens. (If your CAT3.1 system is
‘buried’ in the motorcycle, the audible warning
may not be as loud as you would like. This
extra siren will allow you to position it where
the sound can get out.)
TThhee CCAATT33..11 ccaann bbee ffuurrtthheerr uuppggrraaddeedd;;
Upon request, Acumen will supply you, free of
charge, with a protecting ‘clamshell’ to prevent easy
disconnecting of the alarm system. The clamshell
will prevent easy unplugging of the 6-way
connector.
Please request Acumen part number C-07-0003
TThhee CCAATT33..11 aallssoo hhaass tthhee aabbiilliittyy ttoo bbee ccoonnnneecctteedd ttoo
tthhee ffoolllloowwiinngg ooppttiioonnaall ccoommppoonneennttss;;
1. Starter immobilisation kit
(Acumen part number 10113)
2. Acumen AlarmMate pager
(Acumen part number 10114)
GGeenneerraall SSeeccuurriittyy PPrreeccaauuttiioonnss..
While the Acumen CAT3.1 provides state of the art
electronic security and protection, it will not, by
itself, ensure your motorcycle will not be stolen.
We recommend you undertake basic security
precautions such as;
Parking in a locked garage if possible,
Parking in well lit areas if a garage is not
applicable,
Using a bike cover where appropriate,
Using a chain or shackle and ground anchor.
WWaarrrraannttyy tteerrmmss aanndd CCoonnddiittiioonnss
Full details are given in the Terms and Conditions
document.
www.acumen-electronics.co.uk
To Next Page
Loading...