−−
Drivethevehicleslowlyintwo
complete circles.
In most areas, there is a variation
between magnetic north and true
north. Zone selection is required so
the compass can compensate for this
variation. To check and select the
zone set into the compass, do the
following.
Press and hold the CLOCK and
TRIP buttons until the display
changes (about 1 second).
When the display goes from
‘‘ ’’ to an actual heading, the
unit is calibrated.
Press the CLOCK, TRIP, or
RESET button to complete the
calibration and return the display
to normal.
1.
CONTINUED
Trip Computer
Instruments and Controls
Compass Zone Selection
133
00/08/08 15:39:09 31S3V600_138
To Next Page
Loading...
Need help?
General
