Acura 2001 MDX User Manual

As required by the FCC:
This device complies with Part 15 of the
FCC rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any
interference received, including
interference that may cause undesired
operation.
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user’s
authority to operate the equipment.
This device complies with Industry
Canada Standard RSS-210.
Operation is subject to the following two
conditions: (1) this device may not cause
interference, and (2) this device must
accept any interference that may cause
undesired operation of the device.
Totrainanalreadyprogrammed
transmitter button to operate a new
device:
Select the transmitter button you
want to train.
Press and hold the transmitter
button until the red light begins to
flash slowly (approximately 20
seconds).
Press and hold the button on the
remote control. Hold both buttons
until the red light begins to flash
rapidly.
Release both buttons. The
transmitter should now be trained
to operate the device.
Toerasethecodesstoredinallthree
buttons, press and hold the two
outside buttons until the red light
begins to flash, then release the
buttons.
While continuing to hold the
transmitter button, place the
remotecontrolforthedevice1to
3 inches from the HomeLink
transmitter.
Youshoulderaseallthreecodes
before selling the vehicle.
1.
2.
3.
4.
5.Retraining a Button
Erasing Codes
HomeLink Universal Transmitter
Instruments and Controls
95
00/08/07 22:02:26 31S3V600_100

Acura 2001 MDX Specifications

General

Brand	Acura
Model	2001 MDX
Category	Automobile
Language	English