Install the new bulb in the socket
by pushing it straight in the socket
until it bottoms.
Reinstall the socket into the light
assembly. Turn it clockwise to
lock it in place.
Testthelightstomakesurethe
new bulb is working.
Tighten the mounting nut securely,
and reinstall the maintenance lid.
When reinstalling the taillight
assembly, align and pop the snap
fasteners in place. Tighten the two
mounting bolts and reinstall the
trim in place.
If your seat belts get dirty, use a soft
brush with a mixture of mild soap
and warm water to clean them. Do
not use bleach, dye, or cleaning
solvents. Let the belts air-dry before
you use the vehicle.
Dirt build-up in the loops of the seat
belt anchors can cause the belts to
retract slowly. Wipe the insides of
the loops with a clean cloth
dampened in mild soap and warm
water or isopropyl alcohol.
This filter removes the dust and
pollenthatisbroughtinfromthe
outside through the climate control
system.
Have your dealer replace the filter
when this service is indicated by a
maintenance message on the multi-
information display. It should be
replaced every 15,000 miles (24,000
km) if you drive primarily in urban
areas that have high concentrations
of soot in the air, or if the flow from
theclimatecontrolsystembecomes
less than usual.
9.
10.
11.
12.
13.
Cleaning the Seat BeltsDust and Pollen Filter
Lights, Dust and Pollen Filter, Cleaning the Seat Belts
Maintenance
415
LOOP
０７／０５／１７ ０９：５２：０３ ３１ＳＪＡ６３０ ０４２０
To Next Page
Loading...
Need help?
General
