The handle of each front door has a
sensor. That sensor works with the
remote so you can automatically
unlock/lock the door(s).
By default, only the driver’s door
unlocks when you grab its handle.
If a remote is within operating range
while you wash your vehicle or when
it is raining heavily, the door sensors
may respond by unlocking the doors.
The unlock sensors do not operate
when:
Theremoteisnotwithinthe
operating range.
The remote is too close to the
vehicle.
When the doors are unlocked.
Theremotebatteryisdead.
The vehicle battery is dead.
If you do not open any of the doors
within 30 seconds, they will
automatically relock.
If you wear a glove while grabbing a
front door handle, the door sensor
maybeslowtorespondormaynot
respond by unlocking the doors.
To change the ‘‘KEYLESS ACCESS
BEEP’’ setting, see page .
To change the ‘‘KEYLESS ACCESS
LIGHT FLASH’’ setting, see page
.
When you unlock the door(s), some
exterior lights blink twice and the
system beeps twice.
All the doors unlock when you grab
the handle of the front passenger’s
door.
To change the ‘‘DOOR UNLOCK
MODE’’ setting, see page .
To unlock the remaining doors and
the trunk, press the UNLOCK
button on the remote or the rear of
the master door lock switch on the
driver’s door.
109
111
113
Unlocking the Door(s)
Keyless Access System
Instruments and Controls
169
11/07/20 18:21:30 31SJA670_174
To Next Page
Loading...
