EasyManua.ls Logo

Acura 2012 RL - Front Seat Heaters and Seat Ventilation

Acura 2012 RL
562 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
When you press the button once,
the heater is set to HI. After the seat
reaches a comfortable temperature,
select MID or LOW by pressing the
button. This will keep the seat
warm. To shut down the heater,
press the button until the
indicators go off.
In HI, when the seat gets warm, the
heater will change to MID after
about 5 minutes.
In MID, the heater will change to
LOW after about 60 minutes.
In LOW, the heater runs
continuously.
The ignition switch must be in the
ON (II) position to use the heaters
and the air ventilation system.
HI Three indicators on.
MID Two indicators on.
LO One indicator on.
OFF All indicators off.
To use the heaters, press the
button. The indicator (red) next to
the button will come on. There are
four settings in the heaters:
Both front seats are equipped with
seat heaters and an air ventilation
system. The passenger seat only has
heaters in the seat bottom because
ofthesideairbagsystem.
If equipped
CONTINUED
Front Seat Heaters and Seat Ventilation
Instruments and Controls
183
BUTTON
INDICATORS
Driver’s
seat
HEATERS
BUTTON
FRONT SEAT HEATER AND
SEAT VENTILATION
BUTTONS
Passenger’s
seat
11/07/20 18:23:37 31SJA670_188

Table of Contents

Related product manuals