You can use the kit to inflate a non-punctured under-inflated tire.
1. Open the trunk floor lid.
2 Getting Ready to Temporarily Repair
the Flat Tire P. 478
2. Remove the kit from the case.
3. Place the kit, face up, on flat ground near
the flat tire, away from traffic. Do not
place the kit on its side.
4. Remove the air only hose from the kit.
5. Remove the valve cap.
6. Attach the air only hose onto the tire valve
stem. Screw it until it is tight.
■
Inflating an Under-inflated Tire
Do not operate the temporary tire repair kit
compressor for more than 15 minutes. The
compressor can overheat and become permanently
damaged.
See section on Tire Fill Assist.
2 Tire Fill Assist P. 392
To Next Page
Loading...
Need help?
General
