Remove the socket from the
taillight assembly by turning it
one-quarter turn counterclockwise
and pulling it outward.
If the turn signal light bulb, back-
up bulb, or tail/stoplight bulb is
burned out, remove it by pushing
it in and turning it
counterclockwise. If the taillight
bulb is burned out, remove it by
pulling it straight out of its socket.
Install the new bulb in the socket
in the reverse order of removal.
To reinstall the socket, line up the
tabs on the socket with the slots in
the taillight, push the socket into
thehole,andturnitclockwise
until it locks.
Turn on the lights to make sure
the new bulb is working.
On the passenger’s side, pivot the
CD changer to the upright position,
and tighten the bolt securely.
Install the trunk liner clips by
pushing them straight in. Insert
the top edge of the liner back
under the rubber seal.
If your seat belts get dirty, use a soft
brush with a mixture of mild soap
and warm water to clean them. Do
not use bleach, dye, or cleaning
solvents. Let the belts air dry before
you use the vehicle.
8.
4.
5.
6.
7.
9.
10.
Lights, Cleaning the Seat Belts
Cleaning the Seat Belts
158
０４／０８／１２ １６：３７：３６ ３１ＳＷ０６４０ ０１６１
To Next Page
Loading...
Need help?
General
