Acura RL 2005 - Page 100

▲
▼
▲▼
With the ignition switch in the ON
(II) position, press the INFO button
for more than 3 seconds, then
release it. The CUSTOMIZE ENTRY
screen appears on the multi-
information display.
Select CHG SETTING, and press the
SEL/RESET button.
If you select EXIT and press the
SEL/RESET button, the
CUSTOMIZE GROUP screen is
shown again.
You can customize the WIPER
ACTION in this mode.
Each time you press the INFO ( /
) button, the display changes as
shown in the illustration.
Select WIPER SET UP, and press
the SEL/RESET button.
CONTINUED
Multi-Information Display
Wiper Setup
Instruments and Controls
99
Press the or button.
Press the SEL/RESET button.
Main Menu
Main Menu
Table of Contents