â–²
â–¼
▲▼
With the ignition switch in the ON
(II) position, press the INFO button
for more than 3 seconds, then
release it. The CUSTOMIZE ENTRY
screen appears on the multi-
information display.
Select CHG SETTING, and press the
SEL/RESET button.
Select POSITION SET UP, and press
the SEL/RESET button.
Each time you press the INFO ( /
) button, the display changes as
shown in the illustration.
If you select EXIT by pressing the
SEL/RESET button, the
CUSTOMIZE ENTRY screen is
shown again.
AUTO TILT & TELESCOPIC
MEMORY POSITION LINK
Here are the settings you can
customize in this mode:
CONTINUED
Position Setup
Multi-Information Display
Instruments and Controls
85
Press the or button.
Press the SEL/RESET button.
To Next Page
Loading...
Need help?
General
