11. Sampling Process
The sampling process has been performed by Acus-
tica. The units were sampled with mastering quality
converters, using a method which takes considerably
more time than the normal sampling standard.
This method is of benet to the entire audio spectrum.
Two sample rates are provided with Titanium3; the
native sample frequency was 96kHz. The 44.1kHz
frequency was derived from the native one by a
down-sampling and up-sampling process. This meth-
od avoids any negative sample rate conversion (SRC)
artifacts when matching projects with dierent sam-
ple rates and also helps with project loading times.
12. Operation
Below is an explanation of the Titanium3 suite, rst
we will get into the details of each standalone plugin
to facilitate an understanding of each of the controls
included in this new Acqua Eect Plugin suite.
Unless expressly indicated each control will also be
available in the Titanium3 channel-strip version
Titanium3 COMP 1B standalone plugin
Titanium3 COMP 3B standalone plugin
10
To Next Page
Loading...