Page 14
LASER/DVD 1
3 CHANNELS
LASER/DVD 1
3 CHAN RE-EQ
LASER/DVD 1
MONO EHN
LASER/DVD 1
STEREO EHN
LASER/DVD 1
QUAD BYP EHN
LASER/DVD 1
QUAD BYPASS
3 Channel, Quad, Stereo Enhance, and Mono Enhance
3 Channel Mode- This mode only
engages the front three speaker,
providing Pro Logic steering
across these channels with the
surrounds completely muted. The
subwoofer is active in this mode
assuming it is set to be active for
this input in the Bass Management
section under Pro Setup.
3 Channel Re-EQ Mode- This
mode is like the 3 Channels mode
with the addition of THX Re-EQ.
Quad Bypass Mode- Ideal for
music playback, the right channel
information is sent to the right sur-
round channel and the left chan-
nel information is sent to the left
surround channel. The center
channel (if active, see System
Setup in Pro Setup) is sent a mix
of the right and left channels, with
the mix lowered by 3db.
QUAD BYP ENH Mode - The
Quad Bypass Enhanced mode op-
erates just like the Quad Bypass
mode but adds full THX Enhance-
ments to the surround sound mix.
STEREO ENH Mode - The Ste-
reo Enhanced Mode is ideal for
two channel mixes with limited ste-
reo separation. TV broadcasts
and poorly mixed video tapes will
playback with a fuller use of the
speaker array in this mode. Ste-
reo Enhance couples increased stereo separation without destroy-
ing the mono mix. This proprietary mode uses delay settings to
enhance the surround sound effect. The effect level and delay can
be adjusted in the Pro Setup menu.
MONO ENH Mode - The Mono
Enhance Mode is similar in design
to the Stereo Enhance mode but
is ideal for non-stereo mixes. Thus
old movies and mono TV broad-
casts emanate not just from the
center speaker, but rather, utilize the entire speaker array. Even the
worst audio mixes are spatially enhanced. This mode is also adjust-
able by setting the effect level and delay in the Pro Setup Menu.
3 CHANNELS Mode
This mode provides Pro Logic
decoding with only the three
front channels and the
subwoofer active.
3 CHANN RE-EQ Mode
This 3 channel mode adds re-
equalization to the three front
channels.
QUAD BYPASS Mode
This mode is designed to
utilize the entire speaker array
for two channel music
playback. All four right and
left speakers receive R/L
information and the center
gets a mix of the two.
QUAD BYP EHN Mode
This mode adds THX
Enhancements to the Quad
Bypass mode.
STEREO ENH Mode
This is a proprietary mode
ideal for playback of signals
with limited stereo separation
such as TV broadcasts and
poorly mixed video tapes.
MONO EHN Mode
This mode is ideal for
playback of mono only mixes
as it will utilize the entire
speaker array.
To Next Page
Loading...
Need help?
General
