17
Guidance and manufacture’s declaration - electromagnetic emission
Immunity Test IEC 60601 test level Compliance level
Conducted RF
IEC 61000-4-6
3 Vrms
150 kHz to 80 MHz
Radiated RF
IEC 61000-4-3
Professional healthcare environment:
3 V/m home
Healthcare environment:
10 Vm 80 MHz to 2700 MHz
Professional healthcare environment:
3 V/m home
Healthcare environment:
10 Vm 80 MHz to 2700 MHz
Not applicable
NOTE 1: At 80 MHz and 800 MHz, the higher frequency range applies.
NOTE 2: These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption
and reflection from structures, objects and people.
a) Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless) telephones and
land mobile radios, amateur radio, AM and FM radio broadcast and TV broadcast cannot be predicted theoreti-
cally with accuracy. To access the electromagnetic environment due to fixed RF transmitters, an electromag-
netic site survey should be considered. If the measured field strength in the location in which the Non Contact
Infrared Body Thermometer is used exceeds the applicable RF compliance level above, the Non Contact In-
frared Body Thermometer should be observed to verify normal operation. If abnormal performance is observed,
additional measures may be necessary, such as re-orienting or relocating the Non Contact Infrared Body Ther-
mometer.
b) Over the frequency range 150 kHz to 80 MHz, Field strength should be less than 3 V/m.
The Infrared Body Thermometer is intended for use in the electromagnetic environment specified below. The
customer of the user of the Infrared Body Thermometer should assure that it is used in such an environment.
Guidance and manufacture’s declaration - electromagnetic emission
The Infrared Body Thermometer is intended for use in the electromagnetic environment specified below. The
customer or the user of the Infrared Body Thermometer should assure that it is used in such an environment.
Anti-interference detection IEC 60601 test level Compliance level
Electrostatic discharge (ESD)
IEC 61000-4-2
Contact: +8 KV
Air: +2,+4,+8,+15 KV
Contact: +8 KV
Air: +2,+4,+8,+15 KV
Surge
IEC 61000-4-5
Input power ports: +0.5, +1.0 KV
Signal input/output:+2.0 KV
Not applicable
Surge
IEC 61000-4-5
Voltage dips
IEC 61000-4-11
Voltage interruption
IEC 61000-4-11
Power frequency (5 0 H z / 6 0 H z)
magnetic field IEC 61000-4-8
30A/m 30A/m
NOTE: UT is the a.c. mains voltage prior to application of the test level.
250 (50Hz)/300 (60Hz) cycles for
>95% UT (sync angle (degrees):0)
0.5 cycles for > 95%
(sync angle (degrees):0, 45, 90,
135, 180,225, 270, 315)
1 cycles for >95% UT
(sync angle (degrees):0)
25 (50Hz)/30 (60Hz) cycles for
30% U T (sync angle (degrees):0)
± 1 kV line(s) to line(s)
± 2 kV line(s) to earth
Not applicable
Not applicable
To Next Page
Loading...
