AddEnergie CoRe+VBV2 - Preliminary Tests and Commissioning; Post-Power On Checks; Access Card Authentication Test

12
2016 ADDÉNERGIE TECHNOLOGIES INC. ALL RIGHTS RESERVED. Information and Specications Contained in this Document are Subject to Change, Amendments, and Additions at any Time, Without Notice
V17-2016-03-03
Preliminary Tests and Commissioning
Instructions:
• Apply power to the charging station, the following should be
observed immediately after power is turned on:
1: The status light is on continuously, its color will be green
2: The display shows the greeting message
• Scan the access card provided with the charging head , these
results should be observed:
1: Once the reader detects the card, it will emit an audible bip
2: Immediately after the bip, the access card will be
authenticated by the charging station.
3: If the authentication of the card is successful, the automated
test of the protection circuit will be performed.
4: Once the test is successfully completed, the overhead status
 lightwillstartashing(white).
5: If the connector is inserted into an Electrical Vehicle, it will
begin charging, if not, after 1 minute, the station will be in wait
mode.
• Once the preliminary test is successfully passed, the charging
stationcanthenbeusedasaprivatechargingstation(usingthe
providedaccesscard(s)),ortobeconnectedtoAddÉnergie’s
management system by turning on the communication Gateway
providedbyAddÉnergie.