Alarm
25
CK 2302 DCF radio-controlled clock
English
Alarm
Setting the alarm time
1. Press and hold the button until the hour digit flashes on the display and the
alarm symbol is displayed.
2. Use the button
or to set the desired alarm hour.
The indication of the displayed values changes faster by holding or .
3. Press
.
The minute indicator for the alarm time blinks on the display.
4. Use the button
or to set the desired alarm minute.
5. Finally, press
to complete the setup process.
You can check the set alarm time by briefly pressing the button once.
Waking up
At the set time, you will be woken by an alarm signal, which will become more intense
as the waking time increases. The alarm symbol also flashes on the display.
Interrupting the alarm for 24 hours
− Press any button (except , as it disables the alarm function) to stop the alarm.
After 24 hours, the alarm will be triggered again.
Auto-stop function
If you do not press a button, the alarm switches off automatically after 2 minutes. After
24 hours, the alarm will be triggered again.
Switching the alarm function off and on
Starting from normal time display:
− Press the
button once.
Once the alarm symbol
goes out, the alarm function is disabled and you will not be
alarmed any more. Pressing again activates the alarm function.
To Next Page
Loading...
