M320600-01-160525-Rev002-UM-e 7
Operation
Correct weighing
Under regular operation the scale is switched on either by the “tap on function” or by pressing the
“ “on button.
A short function test comes up and ‘0.00’ appears in the display. The scale is now ready for use.
Step on the platform and avoid movements.
The scale automatically switches off after a period of 90 seconds if not in use, when operated on
batteries.
Turning function
Allows the ready of the display values either from the patient or user side.
How to change the unit
The scale offers the possibility to select between the weighing mode kg and lb. For changing the mode press
the “UNIT” key at the display.
Tare function
The tare function allows ignoring an additional weight placed on the scale.
Start the scale
Place any additional weight on the platform of the weighing scale and press the key.
The display will flash for a short time and will show ‘0.00’. The Net symbol will come up on the
display.
You can remove the additional weight from the platform. The tared weight is being displayed as
negative value.
Step on the platform together with the additional weight.
The scale determines the weight of the patient without the additional weight. You may now use
the scale for as many weighing procedures and the stored value will always be deducted as long
as the scale is not turned off.
To chancel the tare mode press the tare button again or wait until the scale is switched off.
Hold and auto-hold function
The Hold function is being used to keep the weighing results displayed after the weight/load has been re-
moved from the scale. The scale will remember the last setting after switch off and will start in this mode.
Press the HOLD button to activate or deactivate the hold function.
“HOLD” is being displayed on the display.
The weight remains frozen in the display for 90 seconds after unloading the scale.
To deactivate the Hold function press again the HOLD key.
To Next Page
Loading...
Need help?
General
