Starting signal reception
40
Weather station with radio alarm clock WS 1710
Checklist when data is missing in the display
No data display from the time signal transmitter
1. Check whether the location of the base station is suitable, see "Choosing a
location".
2. Restart reception manually, see "Manually starting signal reception".
3. Wait until the base station automatically switches back to reception at a later
time. The reception is usually better at night.
4. Manually perform the settings if reception is not possible at your location, see
"Setting the time and date manually".
No data display from the wireless outdoor sensor
1. Check whether you have inserted the batteries correctly.
2. Check whether the location of the wireless outdoor sensor is suitable, see
"Choosing a location".
3. Press and hold CH to manually start signal reception to the outdoor sensor.
4. When using a single wireless outdoor sensor (standard), transmission channel 1
is usually used for data transmission.
Press the CH button repeatedly until
is shown in the display.
Then, if necessary, check whether the sliding switch on the wireless outdoor
sensor is also set to "1".
Note: You can also use any other transmission channel. However, it must be
identical for the base station and the outdoor sensor.
Setting the time and date manually
If there is more than approx. 20 seconds between two pushes of a
button, the setting process automatically ends and you will have to
repeat it. Settings you have already made remain saved.
The settings are made via the multi-function knob:
Rotate: select setting,
Push: confirm the selected setting.
1. Press and hold the SET button until "24 Hr" or "12 Hr" flashes in the display.
2. Set the desired time format using the multi-function knob.
Druckbuch WS1710 DE EN.indb 40 02.06.2017 13:45:46
To Next Page
Loading...
Need help?
General
