ADE WS 2132 - Setup: General Information and Batteries; Setup: Wireless Outdoor Sensor Battery Installation; Setup: Base Station Battery Installation

51
Weather station with ventilation recommendation WS 2132
English
Startup
General Information
 Proceed according to the order listed below and
rst insert the batteries into the wireless outdoor
sensor. Only then can the weather station function
without aws.
 Do not use rechargeable batteries, since their
voltage is too low (only 1.2 V instead of 1.5 V). This
aects, among other things, the precision of the
measurements.
 Where possible, use alkaline rather than zinc-
carbon batteries. Alkaline batteries last longer,
especially at low outdoor temperatures.
Wireless outdoor sensor
1. Push the battery compartment cover on the back
of the outdoor sensor open using a little force.
2. Insert two LR03/R3 (AAA) batteries as shown on
the bottom of the battery compartment. Observe
the correct polarity (+/-).
3. Slide the battery compartment cover back on.
Base station
1. Press down the locking tab of the battery
compartment cover and fold down the
compartment cover.
2. Insert two LR06/R6 (AA) batteries as shown on the
bottom of the battery compartment. Observe the
correct polarity (+/-).