54
Weather station with ventilation recommendation WS 2132
No data display from the wireless outdoor sensor
1. Check that the batteries are inserted the right
way round.
2. Check whether the location of the wireless outdoor
sensor is suitable; see “Choosing a location”.
3. By default, transmission channel “1” is always
used for data transmission.
1. If necessary, briefly press the - button
repeatedly until
appears on the display.
2. Hold the - button to manually start the
outdoor sensor wireless reception.
Setting the time and date manually
If more than 15 seconds pass between
two button presses, the setting process is
automatically terminated and you have to
repeat it.
1. Press and hold the SET/MODE button until the unit
of measurement for the temperature flashes on
the display (“°C” or “°F”).
2. Use the + or - button to set the desired unit of
measurement.
3. Press the SET/MODE button to save the setting.
The unit of measurement for the air pressure
(“hPa”, “inHg” or “mmHg”) flashes on the display.
To Next Page
Loading...
