20
6 - Fan (for optional inbuilt fan available).
• Must be installed in accordance with AS/NZS 3000.
• Must be installed to the manufacturer’s specifications.
• Power supply must be installed by a licensed electrician.
• If the power cable is damaged, for any reason, do not use. Have the cord replaced
immediately.
• Please follow the fan instructions included with the fan kit.
T
he fan will need a fan cut out in the bench, and with air supply to each fan below the heater base. A
cable will need to run from the heater to a wall mount controller – the 240V power supply is supplied to
the wall mount controller – see the fan instruction manual for more details.
NOT
E: REMOVE THE FEET UNLESS REQUIRED WITH
USING A FAN ON AN EXISTING HEARTH
Warnings
Danger of Electrocution: All electrical work must be carried out by a qualified electrician.
Note: All electrical components should be installed in an airy location away from hot parts
To Next Page
Loading...