ADI AR-446 - Paging Code Memories; Setting the Paging Codes

5-10 PAGING
The paging function is available when the aptional DTMF unit
(DTF146) is installed.
The paging function is useful to call all station a group. a specific
station, or wait for a call from another station by using DTMF (Dual
Tone Multi Frequency signaling.
Example:When station 2 is called
F:145.660MHz
Your code:111
Station 2's code:333
“A
145.660MHz
333 111
Station 2's Your code
F:145.660MHz
F:145.660MHz
: F:145.660MHz
Individual
code:
_
Saint
222
Individual
cede:333
Individual
code:444
Station
2
Station
3
The common group cede and individual codes should be determined
in advance. These codes should be from 000 ta 999 (3 digits). Unlike
C.SQ, the code of the cailing station is displayed on the receiver, so
the receiver can identify the calling station.
When called by a local station, the individual cade of the calling
station is displayed. When called with a group code, that group code
is displayed.
Paging operation procedure
Set your Station code
Tune to frequency of the other station
Enter the paging mode
To stand by fora
Pager
To call the ather
station
Set the code of
station to be called
5-10-1 Pi
There are five
PA
PO
P1~P
5-10-2 S$
1. Press the
will tight.
2. Press the
on. The
channel i
i 5