ADIATEK Opal 66 - Starting of the Machine; Movement and Speed Adjustment; Suction Motor Silent Mode; Working Brake

STARTING OF THE MACHINE
Every control is visualized on the display (1).
1. Turn the key (2) clockwise.
2. Check the battery type and the charge level on the display (1).
3. Press the suction motor push button (3); the suction motor symbol
changes from off to on and the motor starts suck up.
4. Press the solenoid valve push button (4); the solenoid valve symbol
changes from closed to open.
5. Lower the brushes base onto the floor by pressing the push button
(5); on the display is visualized first the down symbol and then the
one of the brushes motor activation.
6. Acting upon the solution valve lever (6
) open and adjust the
detergent solution flow.
7. Models equipped
with the 3S system (optional), it is necessary to
press the suitable push button to activate the detergent solution
supply by choosing between the traditional adjustment system
through the solution valve or the system of fixed optimum supply
(see under “3S SYSTEM SOLUTION SAVING SYSTEM”).
8. Acting upon the squeegee lifting lever (7) lower the squeegee.
9. Acting upon the levers drive control (8
) the machine starts to
move, the brushes start to rotate and the water begins to flow
automatically.
Releasing the drive control levers will stop the flow.
10.
During the first metres check that the squeegee adjustment
guarantees a perfect drying action and that the detergent solution
flow is appropriate. It has to be sufficient to wet the floor
uniformly avoiding the leakage of detergent from the splash
guards. Always
consider that the correct quantity of solution
detergent depends on the type of floor, dirtiness and machine
speed.
MOVEMENT AND SPEED ADJUSTMENT
The traction of the machine is given through an electronically
controlled motor.
To move the machine, act upon
the key (1
) and then rotate the
levers drive control (2) placed on
the handle bar, in forward
for
t
he forward drive, in reverse for
the backward
drive. The control
acts in a progressive way,
therefore it is possible to
graduate the speed depending
on each requiremen
t rotating
the lever
s whatever it is
necessary.
Furthermore it is possible to adjust the maximum speed acting upon
the push button (3) to increase it and on the button (4) to decrease it.
Every change will be visualized through its symbol on the display.
During reverse motion the speed is reduced.
SUCTION MOTOR SILENT MODE
It is possible to start the
silen
t mode of the suction
motor by pressing for a few
seconds the switch
-on
button
(1)
of the suction
motor.
When the silent mode is on, the symbol on the display changes.
WORKING BRAKE
To stop the machine during
normal working situation, it is
sufficient to release the levers
drive control (1), as the
machine is equipped with an
electronic braking system. The
brushes and the
detergent
solution stop automatically
.
13