Page 11
Hints and Tips (Cont.)
2. Article having transfers applied is locked in contact between
pressing pad and heat plate.
3. Pressing pad is in good condition, is flat and making complete
contact over the whole area of the heat plate. See Pressing Pad
details.
“Ghosting” (Double Image) of Transfer Prints
Check:-
1. Material being used has been correctly heat set for transfer
printing.
2. Material being used does not shrink during printing process,
i.e. measure material before and after printing.
3. Transfer paper does not move after printing process upon lift
off of the heat plate.
4. If possible, use adhesive coated paper, particularly to
overcome fabric shrinkage.
5. By pre-shrinking of material in press before transfer printing.
To Next Page
Loading...