ADO A20F Beast - Charger, Washing, and Component Safety; Charger and Washing Precautions; Component Wear and Impact Warnings

Special tips for using security
4safe use method of charger:
It is forbidden to place any items on the charger
It is forbidden to put any liuid or metal into the charger
It is strictly prohibited to disassemble and modify the charger
hen charging, insert the output of the charger into the charging port of the battery pac rst, and then
insert the AC power plug of the charger into the Mains socet It is forbidden to plug and remove the power plug
with wet hands
Do not use the charger when thunder and lightning
Do not play with the charger and battery pac when charging
Do not use the charger in unstable, ecessive lampblac and dust and ecessively humid environments
eep good ventilation and heat dissipation conditions when the charger wors, and avoid using the charger
in direct sunlight;
When the output of the charger is not connected to the battery pack, do not connect the charger to the
mains for a long time
During the charging process, the indicator light of the charger is red. When the indicator light turns green,
continue charging for 2 hours to be fully charged;
The normal charging time is 3-10 hours no more than 12 hours, and the fast charging station is not allowed
to charge.
5recautions for washing:
hen washing the bicycle, do not directly splash water on the brae drum, motor and front and rear ale to
prevent water from aecting the service performance and life
Do not use steam or high-pressure water pipes when washing bicycle 
ay special attention to the woring condition of the brae after cleaning the vehicle or driving in the water.
After cleaning or driving in the water, the braing eect may decrease. At this time, pay attention to safety when
driving slowly.
6Adustment of handlebar and saddle if applicable
hen adusting the handlebar or saddle, be careful not to epose the safety line mar of stem and saddle
pipe;
After adusting the horiontal pipe, stem, saddle and saddle pipe, pay attention to fastening, and the
recommended torue is 18N.m.
ANIN 1  As with all mechanical components, EAC is subected to wear and high stresses. Dierent
materials and components may react to wear or stress fatigue in dierent ways. If the design life of a
component has been eceeded, it may suddenly fail, possibly causing inuries to the rider. Any form of
crac, scratches or change in color in highly stressed areas indicates that the component has been reached
its service life and should be replaced.
Note: when replacing the charger, it should match the battery model；The special charger provided by our
company must be used, and other Chargers are not allowed to charge the battery pac.
ANIN 2  For composite components impact damage may be invisible to the user, the manufacturer
shall eplain the conseuences of impact damage and the conseuences in the event of an impact
composite components should be returned to the manufacturer for inspection or destroyed and replaced.

03