ADO A20F Beast - Pre-Ride Inspection Checklist; Comprehensive Pre-Ride Checks

Precautions before riding
Dear users, for your safety and to prevent safety accidents, please do the following checs before riding. If there
is any abnormality，please repair it in time or nd a professional repair
1Inspection of power supply circuit and lighting circuit:
Chec whether the power supply circuit, lighting circuit and device are damaged Turn on the power supply,
operate the lighting switch, chec whether the headlights and taillights are on, and whether the brightness of the
headlights and taillights is normal
Chec that the left brae handle is corresponding to the rear brae, while the right brae handle is
corresponding to the front brake, and the brake icon is indicated on the display.
2Chec of brae device:
Chec whether the front and rear braes can wor normally Chec the braing eect of the front and rear
braes to ensure that the braes are normal and eective
Conrm whether the power-o switch is normal when the rear wheels are o the ground with double
support of the whole vehicle
lease chec the fastening status of each ale to ensure that the front and rear ales and handlebars are
fastened reliably.
3Chec the fastening status of handlebar and front and bac wheels:
hae the handlebar up, down , front, bac, left and right to chec whether it is loose or pongee
hae left and right front and bac wheels to chec whether there is looseness whether the rotating wheel is
too tight or stuck.
4Tire inspection:
Chec that the wheel ination pressure is within the range mared on the tire.
whether the tire has cracs or abnormal wear
hether the tire is embedded with nails, stones and glass
hen the tire is used to the tread wear mar, the tire should be replaced.
5Inspection of reector and license plate:
Chec whether the reector is missing. If it is found missing, contact the after-sales service immediately to
reassemble the reector of the same specication and model, and the installation position should be consistent
with the original bicycle .lease do not change the position, modify, disassemble, etc. privately.
Before each use, chec that the function of the reector is normal and the surface of the reector is ept
clean.
The eector device cannot be bloced by luggage, children chair, clothes and other obects, otherwise it will
cause potential safety hazards.
Chec whether the license plate is installed rmly, whether the number is clear, whether there is any damage
or pollution, and if there is any should, reinforce, clean or replace it in time.
Chec the front brae and rear brae respectively. The left brae handle corresponds to the front brae and
right brake handle corresponds to the rear brake. The brake icon is indicated on the display.
All endurance mileage data of the battery in this manual are from tests done in AD outdoor test site on
the condition that the battery is full, at 25C, with no wind, and under 65g load. It is normal that the actual
riding mileage may be signicantly dierent due to rider habits, weight, road conditions, weather, etc.
Before each ride, please mae sure that the following items: whether the frame loc，vertical tube lock,
seat tube locing fastener are loced, whether the brae system is normal, and the tires are full of gas to
ensure riding safety!

04