Need help?Do you have a question about the ADS M860 and is the answer not in the manual?
M860 accepts low-level signals via DIN or RCA plugs.
Uses speaker outputs from signal source connected via adapter cables.
Ensures consistent speaker wire polarity for proper phase and imaging.
Procedures for testing the system after installation.
Steps for initial system testing and troubleshooting.
Steps to set high pass and low pass crossover frequencies.
Adjusting amplifier level controls for maximum undistorted sound.
Setting amplifier input level controls for optimal performance.
Explains the thermal protection circuit and causes of overheating.
To Next Page
General
