ADT Model 927 Water Recycling System
P/N 90927-SPPM-000-00
x
If any are damaged or dry– replace.
If not– apply some grease or other lubricant to ensure good sealing.
Attach the white tube with O-rings to the replaced filter element.
Insert the replaced filter element into the filter body.
Insert the second white tube with O-rings into the replaced filter
element top opening.
Place the filter cover, and push down.
Re-assemble the white holding ring.
Rotate the holding ring to an angle the yellow locker can be connected
to the filter cover.
Re-connect the yellow locker to the filter.
3.5 Cleaning the Air Regulator Filter
Inspect the air filter, if it is dirty or filled with water, empty it and clean
it.
3.6 Setup the machine
Before powering on, verify that the EMO button is not pushed in.
To power-on the system:
Toggle the main circuit breaker to the ON position.
Figure 3-13. Main circuit breaker
a. The system goes through an initialization process, of 5 seconds,
and displays the Standby screen.
To Next Page
Loading...