– 12 –
SYSTEM OVERVIEW
About the Display and Indicators
Display Definitions (for other displays, see Trouble Messages)
Alarm: Displayed when the system is armed and an intrusion has been detected
(also appears during a fire alarm or audible emergency alarm).
Accompanied by the protection zone that is in alarm.
Armed Away: All burglary zones, interior and perimeter, are armed.
Armed Stay: Perimeter burglary zones (i.e.: protected windows and doors) are armed.
Exit Now: Displayed during exit delay
Disarmed Ready to Arm: Displayed immediately after system has been disarmed.
Disarmed Ready: Displayed when the system is disarmed and is ready to be armed.
Disarmed NotReady: Displayed when the system is disarmed but is not ready to be armed
AwayInst or StayInst: Entry delay is turned off.
Fire: Displayed when a fire alarm or fire fault is present. Accompanied by a
display of the zone that is in alarm.
LowBat: Low battery condition exists in a wireless sensor (if zone number is
displayed) or low system battery (if no zone number is displayed). If 00 is
displayed, a wireless keypad (5827) has a low battery condition.
No AC: Displayed when AC power is NOT present. If displayed, the system is
operating on backup battery power.
Chime: Displayed when the Chime feature is enabled and the system is disarmed.
Test in Progress: Displayed when the system is in Test mode, blinks during the last 5
minutes of test.
Record Press Off to Stop: Displayed when the system is in Recording mode.
Msg: Displayed when a recorded message has not yet been played back.
Bypass: Displayed when one or more burglary protection zones are bypassed.
Fault: Displayed at any time a malfunction is discovered in the system; or any
time an open is detected in a fire zone; or when a fault in a day/night
burglary zone is discovered during a disarmed period. It will be
accompanied by a display of the zone number in trouble.
PH Speakerphone: Displayed in place of the clock when the speaker phone mode is active.
PC Remote Phone: Displayed during a remote phone control session.
LED Meanings
ARMED LED: ON = System armed
(Red) OFF = System disarmed
Blinking = System armed, but a fault exists
Blinking alternately with READY LED = AVM (VOX or Talk) or
speaker phone mode is active
READY LED: ON = System disarmed, ready to arm
(Green) OFF = System armed
Blinking = System disarmed, not ready to arm (a fault exists)
Blinking alternately with ARMED LED = AVM (VOX or Talk) or
speaker phone mode is active.
To Next Page
Loading...
Need help?
General
