– 7 –
QUICK VIEW OF SYSTEM FUNCTIONS
NOTE: = Boxes represent the entering of your 4-digit user code.
SECURITY FUNCTIONS
Checking system status: --------------- STATUS
To arm in STAY mode: -----------------
*
+ STAY
To restart exit delay: --------------------
*
+ STAY OR STAY
To arm in AWAY mode: ----------------
*
+ AWAY
To arm if Quick Arm is active: ------ AWAY or STAY (hold down for at least 2 seconds)
To disarm system and silence alarms: + OFF
Note: During Entry Delay or when an Alarm Condition exists the system can be disarmed by entering the User Code. Entering the OFF
key is not required
To bypass a zone(s): ---------------------- + BYPASS + 2-digit zone number(s)
To turn Chime mode on or off: ------ FUNCTION + CHIME
*
Security code is not required if Quick Arm is active. Instead, press and hold down the
STAY or AWAY key.
MESSAGE CENTER
To record a message: -------------------- FUNCTION + RECORD
To stop recording before end of 85 secs: OFF
To play back a message: --------------- FUNCTION + PLAY
To skip a message: --------------------------- [✻]
To delete all messages: -------------------- FUNCTION + DELETE (during message replay)
VOLUME ADJUSTMENT
To adjust message playback/announcement volume: FUNCTION + VOLUME + [3] or [6]
To mute system announcements: -- FUNCTION + VOLUME + OFF
To restore/unmute announcements: FUNCTION + VOLUME + [3] or [6]
SPEAKER PHONE OPERATION
To enter speaker phone mode: ------[#] + AUX
To exit speaker phone mode: -------- OFF
To enable/disable (toggle) ringer: -[#] + VOLUME + AUX
To return keypad to telephone mode (after clearing an alarm or trouble or disarming the system): [#] + AUX
To flash (switch between two calls using call waiting): AUX *
*To return to first call wait at least two (2) seconds and enter AUX again.
(only if programmed and
s
stem armed in Sta
mode
To Next Page
Loading...
Need help?
General
