ADT Safewatch QuickConnect Plus User Manual

– 36 –
SYSTEM FUNCTIONS
Maintaining your system
Changing the ADT Safewatch

QuickConnect Plus Security System Battery
In the event of an AC power loss, the ADT Safewatch

QuickConnect Plus Security System is powered
by a rechargeable, nickel-metal hydride battery pack. The battery pack should be replaced when a “Low
Bat” message with no zone number is displayed.
NOTE: The battery pack (P/N LYNXRCHKIT-SC or LYNXRCHKIT-HC) should be changed every four years
and must be replaced by a qualified service technician.
Following battery pack replacement, rechargeable batteries may take up to 48 hours to charge. The
“Low Bat” message may be displayed after one minute, however it should clear within 4 hours or by
entering Test Mode.
It is your responsibility to make sure that your system is in good working order. It's easy to test your
system; just refer to your owner handbook or call 1-888-238-7374 and follow the simple instructions. If
you find that a part of your system is not working properly, call ADT at 1-888-238-7374 to request
repair service.

ADT Safewatch QuickConnect Plus Specifications

General

Brand	ADT
Model	Safewatch QuickConnect Plus
Category	Security System
Language	English