ADT Security Manager 3000 User Manual

– 18 –
'LVDUPLQJDQG6LOHQFLQJ$ODUPV
8VLQJW KH >2 ))@N H\
The OFF key is used to disarm the system, silence alarm and trouble sounds, and
clear alarm memories.
IMPORTANT
:
If you return and the main burglary sounder is on,
DO NOT ENTER, but
CONTACT THE POLICE from a nearby safe location.
If you return after an alarm has occurred and the main sounder has shut itself off,
the touchpad
will beep rapidly upon your entering, indicating that an alarm has occurred during your
absence.
LEAVE AT ONCE, and CONTACT THE POLICE from a nearby safe location.
1.
+ 1
(Security Code)
OFF
The “READY” indicator light will be lit if all zones
are secure, and the touchpad will emit a single tone
to confirm that the system is disarmed.
(-7%61)(
6)%(= 83 %61
English Display:
2.
To Silence a Burglary Alarm and Clear a Memory of
Alarm
Enter your security code and press the OFF key to
silence the alarm (or warning tones of a Memory of
Alarm).
Note the zone in alarm on the touchpad display, and
make that zone intact (close door, window, etc.). Now
enter the security code plus OFF sequence again to
clear the touchpad’s Memory of Alarm display.
Note the zone in alarm on the touchpad display, and
make that zone intact (close door, window, etc.). Now
enter the security code plus OFF sequence again to
clear the touchpad’s Memory of Alarm display.
3. To Silence a Fire Alarm and Clear Memory of Alarm
Simply press the OFF key to silence the alarm. Then
enter the security code plus OFF sequence to clear
the touchpad's Memory of Alarm display. See the
Fire Alarm System section.

ADT Security Manager 3000 Specifications

General

Brand	ADT
Model	Security Manager 3000
Category	Security System
Language	English