ADT Security Manager 3000 - Viewing Current Date and Time; Setting the Date and Time

– 21 –
9LHZLQJ&XUUHQW'DWHDQG7LPH
9LHZLQJ WKH& XUUH QW'DW HDQG 7 LPH
The system lets you view its time and date setting.
+[#] + [6] [3]
(Security Code)
OR, press the function key (A, B, C, or D) for viewing
current date and time, if programmed.
(-7%61)(
6)%(= 83 %61
English Display:
READY
A typical time/date display is shown.
The display will remain on for about 30 seconds.
8-1)(%8) 7%8
%1C
“A” “B” “C” “D”
If one of the above keys has been programmed for the date/time
display feature, place a check mark in the box beneath that key.
6HWWLQJWKH'DWHDQG7LPH
You can set the time and date by doing the following:
1.
+[#] + [6] [3]
(Security Code)
(-7%61)(
6)%(= 83 %61
2. Press [
∗
] when the time/date is displayed.
A cursor appears under the first digit of the hour.
To move cursor ahead, press [
∗
]. To go back, press [#].
•
Enter the 2-digit hour setting.
•
Enter the 2-digit minute setting.
•
Press [1] for PM or [2] for AM.
•
Enter the last two digits of the current year.
•
Enter the 2-digit month setting.
•
Enter the 2-digit day setting.
3. To exit, press [
∗
] when cursor is at the last digit, or
wait 10 seconds.
8-1)(%8) 7%8
41 
Current time display
8-1)(%8) 7%8
4
Time/date editing display