Profiles are specific to decoder settings (ex: Input, Video, Audio, CAS, IP Rx/Tx) and does
not save RF demodulator configurations or System configurations at this time. RF
demodulator profiles may be managed on units with demods via the RF Params tab. Loading
a profile will restart the decoding process with the newly loaded configuration and will save
that configuration for use upon a reboot.
Create New - Creates a new profile of the currently saved decoder state.
Load - Loads or runs the profile
Delete - Deletes the profile from the unit
Download - Downloads the profile to a local file
Web UI - Video
Genlock is used for synchronizing the SDI output to a bi-level or tri-level sync input. More
can be read in the genlock section.
58
To Next Page
Loading...
