waveform teletext on CVBS and SD-SDI, set CVBS to line 22. When set to 0 waveform
teletext is disabled. To enable ancillary digital OP47 teletext on SDI or SDIALT, select a line
number next for the desired output.
VITC - Not supported at this time (2.01.XX)
AFD - AFD is only supported on SDI and SDIALT via SMPTE 2016.
Timecode Configuration - Not supported at this time (2.01.XX)
SMPTE 2038 - The Adtec decoder supports Transport Stream to SDI ancillary data
pass-through via SMPTE 2038.
VBI Stats shows the DID/SDID and data count for the SDI outputs if captions or AFD is
enabled. The AFD code can be seen in hex and the aspect ratio flag is also displayed.
Web UI - TS Output
ASI Tx configures Service Filtering on the ASI Output. Read more in the Service Filtering
section.
ASI Filter - ASI Filter enables or disables the configured RD service filter. Service Filtering
69
To Next Page
Loading...
