ADTEK CM1 Series - Line Speed Unit Selection Details; Shaft Diameter Configuration; PV Decimal Point Configuration; PV Display Scale Factor

CM1-SERIES
14 / 28
Rev 1.3
2018-07-02
A−2−2
Eunit
m/mn
m/mn
yd/mn
pVtyp selected (lNspd)，the fun.
will display
Eunit(Engineer Unit):
Line speed display unit selection
Setting Range:
m/mn: (M/min)
cm/mn: (CM/min)
yd/mn: (Yd/min)
ft/mn: (Ft/min)
&
Cycle selection
Enter
A− 2−3
diamt
)1000
)1000
(9999
pVtyp selected (lNspd) ，the fun.
will display
diamt(Diemeter):
Shaft diameter set
Setting Range:
0.0001~9.9999M(公尺)
Shift
Up
Down
Enter
A−3
pVdp
0
0
)0000
pVdp:Decimal Point of PV；
There are two definitions for
thissetting:
1. If fun. setting is auto，the pVdp set
point for the relay output of decimal
places set；
2. If fun. setting is semior manul，the
pVdp set point for the relay output &
PV of decimal places set；
Setting Range:
0 / )0 /
)00 / )000 / 0.0000
&
Cycle selection
Enter
A−4
factr
!000
!000
(999
factr(Factor): Display scale factor；
Display value = calculated value x scale
factor
Setting Range: 0.001~9.999
Shift
Up
Down
Enter
A−5
lOcut
0
00000
00100
lOcut (Low Cut): Low Cut the PV
Low Cut setting +0.50
[lOcut]is setting 0.50，when PV between
-0.50~+0.50，Display is “0”。
PV linear
PV 值
Low Cut
Function
0.50
-0.50
)50
[ lOcut]
Setting Range:
-19999~+29999 counts
Shift
Up
Down
Enter
Low Cut setting -0.10
-0.10
Low cut
function
[lOcut]is setting -0.10，PVLess
than equal to (< = -0.10)，Display is
“-0.10”。
P V 值
PV linear
-)10
[ lOcut]
A−6
itOmd
auto
auto
manul
itOmd:Input Time Out Mode
When the frequency is too low,
this table shows the calculation based
on this function to set the time zero value。
Setting Range:
auto(Auto): Automatic calculation
zero display timo。
manul(Manual): Manually calculation
zero display timo。
&
Cycle selection
Enter
A−7
ito
)0
)0
%0
itOmd selected manul，the Fun.
desplay
ito(Input Time Out): Zero time
setting
。
When the frequency is too low to
display zero value(TIME OUT) time setting
Setting Range: 0.0 sec~999.9sec
Shift
Up
Down
Enter