ADTEK CM1 Series - Front Panel Operation Guide; Display and Indicator Functions; Operating Key Functions; Pass Code Security

CM1-SERIES
4 / 28
Rev 1.3
2018-07-02
■ OPERATING
■ FRONT PANEL
~A
Engineer Unit
Display
screen
R L 1
COM
RL2
Relay status
indication
Communication
status indication
 Number screen:
●
: red high-brightness LED.
 Output LED:
● Relay Energized: 2 square red LED
RL1
display when Relay 1 energized
RL2
display when Relay 2 energized;；
COM
RS485 Communication: 1 square orange LED;
COM
will
flash when the meter is receive or send data, and
COM
flash
quickly means the data transient quicker.。
 Stickers: Each instrument will be attached to the
relay function are engineering
units stickers and stickers; Please choose according
to site usage label affixed to the front panel functions
and units。
● Stickers:
H i
Hi Action
L o
Lo Action
●
Hi. H
Hi Action &Hold
Lo. H
Lo Action &Hold
● Unit stickers: 106 kinds
 Operating Key: 4 keys for
Enter(Function) /
Shift(Escape) /
Up key /
Down key
 Pass Code:
4-digit password to set; To enter the parameter screen,
you must enter the correct
password, please remember the password. If youforget
the password, please contact the company. This
password can be in steps [Pcode] to change
■ OPERATING KEY:
*Please access to the Programming Level to check and set the parameters when users start to run the meter
 Operating Key: 4 keys for
Enter(Function) /
Shift(Escape) /
Up key /
Down key
 The meter has designed operation similar as PC's
and
Enter
. In any page, press
key means "enter" or "confirm setting", and
press
key means "escape(
Esc
)" or "shift".
 In Programming Level, the screen will return to Measuring Page after do not press any key over 2 minutes, or press
for 1 second.
Function Index
Setting Status
(=
)
Enter/Fun key
(1) In any page, press
to access the level or function index
(2) From the function index to access setting status
(3) Setting Confirmed, save to EEProm and go to next
function index
(=
)
Shift key
(1) In measuring page, press
for 1 second to access user level.
(2) In function index, press
for 1 second to go back upper level.
(3) In function group index, press
for 1 second to go back
measuring page
(4) In setting status, press
to Shift the setting position.
(5) In setting status, press
for 1 second to abort setting
and go back this function index.
(=
)
Up key
(1) In function index, press
to go back to previous function index
(2) In setting status for function, press
to select function
(3) During number Setting, press
can roll the digit up
(=
)
Down key
(1) In Function Index Page, press
will go to the next Function
Index Page.
(2) In setting status for function, press
to select
function
(3) During number Setting, press
can roll the digit
down.