ADTEK CM1 Series - User Level Operating Diagram; Measuring Page Functions; Model and Firmware Version Display; Resetting Max;Min PV Values

CM1-SERIES
8 / 28
Rev 1.3
2018-07-02
 OPERATING DIAGRAM (Into the User Level)
9999
1Sec
0-01
min
0-02
max
0-03
Mrst
MEASURING
PAGE
Minimum value
of PV saving
Maximum value
of PV saving
Reset the saved
value of Maximum
& Minimum
0-04
ry!sp
Relay1 Set-point
1Sec
0-07
cm!va
0-06
rYrst
0-05
ry@sp
model of the meter
firmware version
Reset for
energized Latch of
Relay
Relay 2 Set-point
INDEX
Step
FUNCTION DESCRIPTION
PARAMETERS & SETTING
SET
POWER ON
Please check the specification
and wiring diagrams firstly.
*****
Self-diagnosis
(LED All bright)
cm!va
Model
cm!va: Voltage / Current
cm!pr: DC 0~10V / 0~20mA
cm1-tr: Pt100Ω / Pt1000Ω
cm!rl: RPM / Line speed
cm1-f: Frequency
ver!0
Firmware version
9999
Measuring Page
Press
for 1 second return to Measuring Page
0−01
min
)0
min (PV Minimum storage): the Minimum
value of PV saving
When the meter power is turned on, both began to record
shows that the minimum value had occurred；
Except by [Mrst] (step 0-03) to perform cleanup functions
or instrument off; otherwise been recorded
and stored automatically update the new value.
Checking only
0−02
max
99(9
max (PV Maximum storage): the Maximum
value of PV saving
When the meter power is turned on, both began torecord
shows
that the maximum value has occurred;Except through [Mrst]
(step 0-03) to perform cleanup functions
or instrument off; otherwise will always be
recorded and stored the new value is automatically updated
Checking only
0−03
Mrst
no
no
yes
Mrst (Maximum & Minimum reset): Reset
the saved value of Maximum & Minimum
Be stored maximum / minimum values, this functioncan
be removed. This meter will be removed immediately after
the relatively new storage maximum/ minimum values。
Setting Range: yes / no
yes(Yes): Clear the
stored maximum /minimum
value
no(No): Does not clear the
storedmaximum / minimum
values
&
Cycle selection
Determine