ADTEK CM1 Series - User Level Parameter Access; Relay Set-point Configuration; Resetting Relay Hold Status; Meter Information Display

CM1-SERIES
9 / 28
Rev 1.3
2018-07-02
0−04
ry!sp
10)0
10)0
10)9
99(9
ry!sp (Set-point of relay 1): Relay 1
Set-point
Setting Range: -1999~9999
(CM1-RL/CM1-F:-19999~99999)
Shift
Up
Down
Enter
0−05
ry@sp
10)0
10)0
10)9
99(9
ry@sp (Set-point of relay 2): Relay 2
Set-point
Setting Range: -1999~9999
(CM1-RL/CM1-F:-19999~99999)
Shift
Up
Down
Enter
0−06
rYrst
no
no
yes
rYrst (Reset relay hold): Reset for
energized Latch of Relay
Setting Range: NO/YES
Shift
Up
Down
Enter
0−07
cm!va
ver!0
cm!va: model of the meter firmware version
cm!va(CM1-VA): Voltage / Current
cm!pr(CM1-PR): DC 0~10V / 0~20Ma
CM1-TR(CM1-TR): Pt100Ω / Pt1000Ω
cm!rl(CM1-RL): RPM / line speed
cm1-f(CM1-F): Frequency
ver!0(Ver 1.0): firmware version
Checking only；The model
number and software version will differ
according to different models
0−01
min
)0
Cyclic to first page
Under the screen in any of the above
Press
for 1 sec. back to
Measuring
 Into the Programming Level
INDEX
Step
FUNCTION DESCRIPTION
PARAMETERS & SETTING
SET
99(9
Measuring display
enter
Pcode
Default:1000
0000
0000
1000
Pass code screen
To change the password set to
Step A-11, and do not forget
the password
Pass Code
Pass code input
Press
Into
Programming Level
YES
Press
1 Sec Can back to Measuring display
theMeasuring display