ADTEK CM1 Series - Relay Operation Modes; Relay Energized Mode Selection; Hi;Lo Relay Energized Explanation; Start Delay Band and Time

CM1-SERIES
17 / 28
Rev 1.3
2018-07-02
B−3
ry!md
hi
hi
hIhld
ry!md :Relay 1 energized mode
Hi / Lo R e la y E n e rg i ze d
Hi
Setting
ENERGIZED
ON
Low
ENERGIZED
ON
hi
lo
[ry1.sp]
[ry1.sp]
[ry1.md]
R e la y E n e rg i z e d L a t ch & Reset
Hi. HLd(Hi Latch)
relay energized
ON
Reset relay Latch
by ECI or Front Key
ON
Level Trigger
HI
hIhld
[ry1.md]
rYrst
[ dNkey]
[ry1.sp]
Programmable:
off(Turn off the Relay)：Turn
off the Relay andindication LED.
lo(Low Level Energized)：
Low Level Energized;Relay will
energize when PV <Set-Point.
hi (High Level Energized)：
High Level Energized;Relay will
energize when PV >Set-Point.
hIhld / lOhld (High / Low
Level energized hold)：High / Low
Level energize andlatch; As the PV
Higher (or lower) than set-point, the
relay will be energized to latch
except manual reset by from
key in [User Level], front key
function or terminals of E.C.I.
closed
&
Cycle selection
Enter
B−4
ry!hy
)0
00)0
50)0
ry!hy:Relay 1 Hysteresis
Energized / De-energized
Delay & Hysteresis
ON
Hysteresis
De-energized
delay
Hi Setting
Relay
Energized
[ry!sp]
[ry!hy]
[ry!rd]
[ry!fd]
Energized delay
Setting Range: 0~5000 counts
Shift
Up
Down
Enter
B−5
ry!rd
)0)0
)0)0
(5(9
ry!rd :Relay 1 energized delay
time
Setting Range: 0:00.0~9(m):59.9(s)
Shift
Up
Down
Enter
B−6
ry!fd
)0)0
)0)0
(5(9
ry!fd :Relay 1 de-e6nergized
delay time
Setting Range: 0:00.0~9(m):59.9(s)
Shift
Up
Down
Enter
B−7
ry@md
hi
hi
hIhld
ry@md :Relay 2 energized mode
Setting Range:
the same as ry!md
Off lo hi hIhld
lOhld
&
Cycle selection
Enter
B−8
ry@hy
)0
00)0
50)0
ry@hy:Relay 2 Hysteresis
Setting Range: 0~5000 counts
the same as ry@hy
Shift
Up
Down
Enter